Free shipping on orders over $15

Shopping Cart

  • No products in the cart.

FT232 USB UART Board (Type C), USB To UART (TTL) Communication Module, USB-C Connector

$6.00 $4.80

  • Shipping Icon
    Free
    Shipping
  • Shipping Icon
    Safe
    Payment
  • Shipping Icon
    Best
    Services
Categories :
  • Electrical
  • The Original FT232 onboard USB to Serial UART Converter Module is compatible with various operating systems such as Mac OS, Linux, Android, WinCE, and Windows 7/8/8.1/10/11. It features three VCCIO power modes that can be set using jumpers. In the 5V mode, it provides a 5V output, while in the 3.3V mode, it offers a 3.3V output. By opening the jumper, it can be powered from the target board with a voltage range of 3.3V to 5V. The module includes three LED indicators for TXD, RXD, and power status. It has accessible pins for TXD, RXD, RTS#, and CTS# through pin headers. Other pins can be easily connected to a user application system using drilled holes, and the pin pitch is compatible with a universal prototype board.

    Features

    Original FT232RL onboard

    Supports Mac OS, Linux, Android, WinCE, Windows 7/8/8.1/10/11.

    3x VCCIO power mode via jumper setting:

    VCCIO – 5V:5V output
    VCCIO – 3.3V:3.3V output
    open the jumper:powered from target board (3.3V-5V)

    3x LED indicators: TXD, RXD, PWR

    Pins accessible on pinheaders: TXD, RXD, RTS#, CTS#

    Other pins are accessible on drilled holes, easily connected to user application system (the pin pitch is compatible with universal prototype board)

    Package Content
    Weight:0.012 kg

    FT232 USB UART Board (Type C) x1

    6-pin custom connector jumper wire x1

    5-pin male pinheader & 5-pin female pinheader x2

    Resources
    Wiki:FT232_USB_UART_Board_(Type_C)

    FT232USB-C To UART Module
    Adopts FT232RL, Compatible With 3.3V/5V Logic Level

    FT232 Solution

    Hardware Connection
    In The Case Of Working With MCU

    VCCIO 3.3V or 5V output (the module is powered from USB, and the onboard jumper should be shorted to 3.3V or 5V)
    GND GND
    TXD MCU.RX (signal direction: MCU.RX << FT232 << PC.TX) RXD MCU.TX (signal direction: MCU.TX >> FT232 >> PC.RX)
    RTS MCU.CTS (signal direction: MCU.CTS << FT232 << PC.RTS) CTS MCU.RTS (signal direction: MCU.RTS >> FT232 >> PC.CTS)

    CAUTION: the module is compatible with TTL level ONLY, to avoiding any damage, please DON’T direct connect it to RS232 circuit.
    Outline Dimensions

    Add a Review

    Your email address will not be published. Required fields are marked *