The SparkFun MicroMod ATP Carrier Board is a MicroMod Processor Board with Access All The Pins (i.e. ATP). The MicroMod ATP Carrier Board includes a location for a MicroMod Processor Board. The board has a built-in backup battery for Processor Boards with an RTC. The USB Type C connector is used to power, program the processor board, or pass serial data to a serial terminal. The board can be powered from the VIN pin with a recommended voltage between 3.3V to 6.0V. It can also be powered with 5V from the USB C connector. This board breaks out the MicroMod Processor Board’s pins on the M.2 connector to 0.1″ spaced female headers and PTH pads on the edge of the board.The reset button will reset the processor. The boot button will put the processor into a special boot mode. Depending on the processor board, this boot pin may not be connected. There are two locations on the board for Qwiic-enabled device. The board is 3.30″x2.20″. There are 4x mounting holes on each corner of the board. There are 2x additional mounting holes by the SparkFun logo for Qwiic-enabled devices.
Key Features

M.2 Connector

Operating Voltage Range

~3.3V to 6.0V (via VIN to AP7361C 3.3V Voltage Regulator)
3.3V (via 3V3)

Ports

1x USB type C
1x USB type A Host
2x Qwiic Enabled I2C
1x CAN
1x I2S
2x SPI
2x UARTs
2x Dedicated Analog Pins
2x Dedicated PWM Pins
2x Dedicated Digital Pins
12x General Purpose Input Output Pins
1x SWD 2×5 header

1mAh battery backup for RTC

Buttons

Reset
Boot

LEDs

Power
3.3V

Phillips #0 M2.5x3mm screw included

Resources

Getting Started with MicroMod

Designing with MicroMod

MicroMod Info Page

MicroMod Forums

Schematic

Eagle Files

Hookup Guide

Board Dimensions

GitHub Hardware Repo

SparkFun MicroMod Ecosystem Video