The Core407Z STM32 Development Board is a small and ready-to-run system that features an STM32F407ZxT6 microcontroller, which is part of the STM32F family. It is ideal for application development and supports further expansion. The board integrates a USB communication interface, JTAG/SWD programming/debugging interface, clock circuit, USB power management, boot mode selection, and more. Additionally, the pin headers on the backside of the board allow it to be easily plugged into an application board and serve as the MCU core circuit in your system. All I/O ports are accessible on the pin headers, and the header pitch is designed as 2.00mm.
Features:

Microcontroller: STM32F407ZxT6

USB Communication Interface: Yes

JTAG/SWD Programming/Debugging Interface: Yes

Clock Circuit: Yes

USB Power Management: Yes

Boot Mode Selection: Yes

Pin Headers: Yes (2.00mm pitch)

System Integration: Yes

Ready-to-Run: Yes

Expansion Support: Yes

Package Content

Core407Z development board x 1

USB type A to Mini-B cable x 1

Software CD x 1

Development Resources

Related software (KEIL etc.)
Examples in C
Schematic (PDF)
Development documentations

Wiki: www.waveshare.com/wiki/Core407Z
What’s On Board

STM32F407ZxT6 (STM32F407ZET6 by default):the high performance STM32 MCU which features:

Core: Cortex-M4 32-bit RISC
Feature: a full set of single-cycle DSP instruction
Operating Frequency: 168MHz, 210 DMIPS/1.25 DMIPS/MHz
Operating Voltage: 1.8V-3.6V
Package: LQFP144
Memories: 512kB/1024kB Flash, 192+4kB SRAM
MCU communication Interfaces:

3 x SPI, 4 x USART, 2 x UART, 2 x I2S, 3 x I2C
1 x FSMC, 1 x SDIO, 2 x CAN
1 x USB 2.0 high-speed/full-speed device/host/OTG controller with dedicated DMA, ULPI and on-chip full-speed PHY
1 x 10/100 Ethernet MAC
1 x 8 to 14-bit parallel camera interface

AD & DA converters: 3 x AD (12-bit, 1us, shares 24 channels); 2 x DA (12-bit)
Debugging/Programming: supports JTAG/SWD (serial wire debug) interfaces, supports IAP
AMS1117-3.3 (on bottom side): 3.3V voltage regulator
MIC2075 (on bottom side): onboard USB power management device
Power supply switch, powered from 5Vin or USB connection
Boot mode switch, for configuring BOOT0 pin
Power indicator
VBUS LED
Reset button
8M crystal oscillator (on bottom side)
32.768K crystal (on bottom side), for internal RTC with calibration
JTAG/SWD interface: for debugging/programming
USB interface

as DEVICE, used for establishing USB communication between PC and the STM32 development board
as HOST, connecting to USB devices such as USB flash drive through a USB OTG cable

MCU pins expander, VCC, GND and all the I/O ports are accessible on expansion connectors for further expansion
5Vin pinheader, 5V power supply is required when using USB HOST/OTG
USB HOST/OTG jumper

short the jumper when using USB HOST/OTG
open the jumper to disconnect from I/O port

VBAT selection jumper

short the jumper to use system power supply
open the jumper to connect the VBAT to external power, such as battery

VREF selection jumper

short the jumper to connect VREF+ to VCC
open the jumper to connect VREF+ to other custom pin via jumper wire

Dimensions

Photos